How to connect a servo motor?

#1 · March 13, 2025, 12:03 pm

Hi,

how can I connect a servo motor (GND, VCC, Signal) to the board? Are GND, 3V3 and e.g. IO13 / GPIO 13 correct?

Is this inlcuded in the RoboHeart Library or is a another Library required (ESP32Servo).

Any help is very much appreciated!

#2 · March 14, 2025, 3:20 pm

Hello,
Thank you for question. We are currently collecting feedback from some of the first ones to use the board (like you!) and want to implement it for everyone's ease-of-use in the maker space!
Currently, we only have a library on Arduino for a stepper motor, not for a servo motor yet. We are working on writing one. As for the ESP32Servo library on Arduino, we have not tested it ourselves.
We will relay this to our developers and get back to you soon about this! Thanks again for your feedback, we fully appreciate it!
Best regards,
Team RoboHeart